Short answer: A dishwasher not draining is usually blocked, not broken. Check the filter and sump first, then the garbage disposal (and its knockout plug after a new install), the air gap beside the faucet and the drain hose. If all are clear and the pump hums or stays silent, the drain pump has likely failed — typically $190–$330 in Los Angeles.

Check the likely cause and the price

This guide is for homeowners, renters and property managers in Los Angeles, Orange and Ventura counties who open the dishwasher to dirty standing water. It covers the seven causes in the order technicians find them, the checks you can do safely, and what each repair costs.

Why is my dishwasher not draining?

Because something on the water's way out is blocked or has stopped working. Water leaves through the filter, the drain pump, the drain hose, the air gap or high loop, and then the disposal or sink drain. A clog or kink anywhere on that path leaves water in the tub. Here are the seven causes in the order we usually find them.

CauseThe tellFixTypical LA price
1. Clogged filter or sumpDirty water over the filter, food packed on the screenRinse the filter, clear the sumpFree to do yourself
2. Full disposal or knockout plugDisposal was full, or a disposal was just installedRun the disposal; remove the plugFree to do yourself
3. Clogged air gapWater spurts from the cap beside the faucetClean the air gapFree to do yourself
4. Kinked or crushed drain hoseStarted after the dishwasher was moved or the cabinet reorganizedStraighten, clear or replace the hosePriced after diagnosis
5. Jammed or failed drain pumpHumming with no water moving, or silence at the drain stepClear the jam or replace the pump$190–$330 for a new pump
6. Stuck check valveTub drains, then dirty water flows back inClean or replace the valvePriced after diagnosis
7. Clogged house drainThe kitchen sink drains slowly tooCall a plumberPlumbing, not appliance repair

1. A clogged filter or sump

Many current dishwashers have a manual filter — a mesh cylinder over a flat screen in the bottom of the tub — that needs regular rinsing. The sump is the well under it where water collects for the pump; when the filter packs with food, the pump starves. A little clear water under the filter is normal; dirty water above it after a finished cycle is not.

2. The garbage disposal

Where the dishwasher drains into a disposal, a full disposal blocks it, so run the disposal before starting the dishwasher. After a new disposal install, suspect the knockout plug — a plastic disc left inside the disposal's dishwasher inlet. KitchenAid's check: with the disposal's power off and the dishwasher hose disconnected, slide a pencil into the inlet; if it goes in about 3 inches, the plug is out. If it's still there, it has to be knocked out and retrieved from inside the disposal with the power off — a quick job for the installer or a technician.

3. A clogged air gap

The air gap is the small cap on the sink deck next to the faucet. Water spurting out of it during the drain means it, or the short hose below it, is clogged.

4. A kinked or crushed drain hose

The hose kinks when the dishwasher is pushed back into its opening, or gets crushed by things stored under the sink. As the photo shows, the connections sit just above the floor, under the machine. Where there's no air gap, the hose should rise in a high loop fastened under the counter so sink water can't siphon back in.

Braided water supply line and gray hose connections under a dishwasher, seen from floor level on a wood floor
From a Pros Fix Appliances service call: the water supply line and hose connections under a dishwasher.

5. A jammed or failed drain pump

The drain pump is the small motor that pushes water out at the end of each wash. Humming with no water moving usually means glass, a fruit pit or a bone has jammed it; silence at the drain step means the pump has failed or isn't getting power from the control. If you hear grinding or crunching instead, see our guide to a dishwasher grinding noise.

6. A stuck check valve

A check valve is a one-way flap that keeps drained water from flowing back into the tub. If the tub empties and then fills back up with dirty water, the valve is stuck open — or the hose has no air gap or high loop.

7. A clogged kitchen drain

If the sink drains slowly too, the clog is in the house drain past the dishwasher. That's a plumber's job, not an appliance repair.

What can you safely check yourself?

You'll need a cup, a sponge, gloves and a soft brush. Work in this order:

  1. Turn the dishwasher off and switch off its breaker, or unplug it under the sink. Never reach into the sump with the power on.
  2. Bail out the water and sponge up the rest. Wear gloves — broken glass collects here.
  3. Remove the filter, wash it under the tap with mild soap and a soft brush, and check the opening below it for glass, pits or labels. Lock it back in place.
  4. Run the disposal for a few seconds. If it's new, check its dishwasher inlet for the knockout plug.
  5. Pull off the air gap cap, clear any debris, and look for kinks in the hose under the sink.
  6. Restore power and run an empty rinse or short cycle to test.

Stop and call if water has reached the outlet or wiring under the sink, the pump still hums with a clean filter, the hose is cracked, or the next step means pulling a built-in dishwasher out of its opening.

Why does water come out of the air gap?

Because the air gap or the hose from it to the disposal is clogged, so drain water escapes up through the cap. Clean the cap and that short hose; if it still spurts, the blockage is in the disposal inlet or the drain.

Many California kitchens have an air gap because the California Plumbing Code (section 807.3) doesn't allow a home dishwasher to connect directly to a drain or disposal without an approved air gap fitting. Don't remove it to fix a clog; clean it.

What does a drain repair cost in Los Angeles?

Clearing the filter, disposal or air gap yourself costs nothing. Our dishwasher diagnostic is $69 — trip, testing and a written quote — and it's applied to the repair when you approve it; if you decline, the $69 is all you pay. A new drain pump typically runs $190–$330 in Los Angeles, Orange and Ventura counties, parts and labor, with the same fees in all three counties and no travel charge.

Use the 50% rule to decide: repair when the quote is under half the price of a comparable new dishwasher and the machine has life left — roughly 10–12 years for a mainstream model. A drain pump on a five-year-old dishwasher is an easy yes; on a 13-year-old unit, replacement is often the better buy.

When should you call a technician?

Call when the filter, disposal, air gap and hose are clear and the water is still there, when the pump hums or stays silent, or when water is reaching the floor — shut the water valve under the sink first. After your checks, stop bailing — the technician wants to watch it try to drain. Calls placed before noon are usually seen the same day across Los Angeles, Orange and Ventura counties; later calls are typically next business day. Call (866) 696-7767 or book online, and see our dishwasher repair service for what we fix.

Seeing a code? Our guides to Bosch E24 and E15 errors and Miele F11 and F13 faults cover the brand-specific steps.

Frequently asked questions

Is it normal to have some water in the bottom of the dishwasher?

A little clear water under the filter is normal on many models — Whirlpool says it keeps the seals from drying out. Dirty water sitting over the filter after a finished cycle means the drain path is blocked.

Can a garbage disposal stop a dishwasher from draining?

Yes. Where the dishwasher drains through a disposal, a full disposal, a clogged inlet or a knockout plug left in a new unit will stop the drain. Run the disposal before each load, and check the inlet after any disposal install.

How do I unclog a dishwasher drain myself?

Switch off the power, bail out the water, rinse the filter and check the sump. Then run the disposal, clean the air gap cap and straighten the drain hose. If an empty rinse cycle still leaves water behind, the pump, check valve or house drain is the problem.

Does a dishwasher need an air gap in California?

The California Plumbing Code (section 807.3) says a home dishwasher can't connect directly to a drain or disposal without an approved air gap fitting, installed with its flood-level mark at or above the sink's flood level. For a remodel, your city's building department can tell you what it inspects for.

How much does it cost to fix a dishwasher that won't drain in Los Angeles?

The dishwasher diagnostic is $69 and is applied to the repair if you approve it. A new drain pump typically runs $190–$330 in Los Angeles, Orange and Ventura counties, parts and labor included, and the exact price is written before any work starts.

What's your dishwasher doing?

Still not working? Call before noon and we can usually be there today.

Appliance Dishwasher
What's the dishwasher doing?
Diagnostic
$69applied to the repair
Same-day
Call before noonMost LA, OC & Ventura calls seen today
Warranty
30–90 daysparts and labor
Registered
BHGS A49955insured, independent

Emanuel “Manny” MisayeledisOwner of Pros Fix Appliances in Glendale (California BHGS registration A49955). Repairs residential and built-in appliances across Los Angeles, Orange and Ventura counties, including the luxury residences and senior-living communities the company services.