Basement laundry room with an older white top-load washer, a matching dryer and a stainless utility sink

Kenmore Appliance Repair in Los Angeles: Who Built It and What Breaks

Short answer: Kenmore never made its own appliances. Whirlpool, LG, Frigidaire, GE, Samsung and others built them for Sears, and the three digits before the dot in the model number usually show which. For Kenmore appliance repair in Los Angeles, that maker sets the parts and the price: most common repairs run $140–$420 after a $69 or $85 diagnostic.

This guide is for Kenmore owners in Los Angeles County and Orange County. It shows how to tell who built your washer, dryer, refrigerator, dishwasher or range, what usually fails, how parts work now, and when a repair is worth the money.

Who actually made your Kenmore?

A Kenmore appliance was built by another manufacturer, not by Kenmore. Kenmore is a store brand that Sears created, and Transformco has owned it since Sears Holdings sold its assets in 2019.

The builders have included Whirlpool, LG, Electrolux (Frigidaire), GE, Samsung and Panasonic. A Kenmore is usually a version of one of the maker’s own models and shares most of its mechanical parts with them, so every Kenmore repair starts by identifying the maker.

How do you read a Kenmore model number?

The three digits before the dot in a Kenmore model number usually identify the company that built the appliance; a Kenmore model number reads like 110.xxxxxxxx. The model tag is usually inside the fresh-food compartment on refrigerators, and around the door opening or on the back panel on washers and dryers. Our guide to finding the model number on any appliance covers the other spots.

Prefix Likely maker Where you’ll usually see it
106 Whirlpool Refrigerators
110 Whirlpool Washers and dryers
665 Whirlpool Dishwashers
596 Amana (now a Whirlpool brand) Refrigerators
795 LG Refrigerators
796 LG Washers and dryers
253 Frigidaire (Electrolux) Refrigerators
790 Frigidaire (Electrolux) Ranges
363 GE Refrigerators
401 Samsung Varies by product

Treat the prefix as the likely maker, not a guarantee. The list is long-standing knowledge among appliance servicers rather than a table Sears publishes, and a few prefixes have been shared by two makers, so the technician confirms the maker from the full model number.

Are Kenmore parts the same as Whirlpool or LG parts?

Kenmore parts are usually the same as the original maker’s parts when the maker matches. A Whirlpool-built Kenmore (106, 110 or 665) generally takes the same pumps, valves, belts, heaters and sensors as its Whirlpool sibling, and an LG-built Kenmore uses LG components. Parts from a different maker don’t interchange, so parts are matched to the full Kenmore model number, never to the badge. AppliancePartsPros explains how Kenmore and Whirlpool parts line up.

Sears’ decline hasn’t stranded most Kenmore owners. Sears PartsDirect still lists parts by Kenmore model number, and the maker’s own parts network covers the shared components. The parts that get hard to find are the ones made only for the Kenmore version, such as a control console or a trim piece, and on an older appliance that’s often where replacement starts to make sense.

Common Kenmore washer and dryer failures

Kenmore washers and dryers fail the same way as the Whirlpool or LG machines they’re built on, so each symptom points to a few likely parts.

Washers

  • Won’t drain: a clogged pump filter or a failed drain pump.
  • Won’t start or spin: the lid switch or door lock. Older Whirlpool-built direct-drive top-loaders also wear out the plastic motor coupler.
  • Leaks at the front: a torn door boot, the rubber seal around a front-loader’s opening.
  • Bangs on spin: worn suspension rods or shocks.
  • Roars on spin: tub bearings, usually the point where an older washer is replaced instead.

Dryers

  • No heat, electric: a thermal fuse, thermostat or heating element. A blown fuse usually means a restricted vent, so the vent gets cleaned too.
  • No heat, gas: the igniter or the gas valve coils.
  • Squeaks, thumps or won’t turn: the belt, drum rollers or idler pulley.

Many Whirlpool-built machines show F#E# error codes, and our Whirlpool error codes guide explains how to read them, though your Kenmore’s manual has the final word on what a code means. Our washer repair and dryer repair pages explain what a visit involves.

Common Kenmore refrigerator failures

Kenmore refrigerators fail in the same few ways whether Whirlpool (106), LG (795), Frigidaire (253), GE (363) or Amana (596) built them:

  • Fridge warm, freezer cold: a defrost failure or a dead evaporator fan. Our guide to a refrigerator that isn’t cooling while the freezer works walks through it.
  • Clicks every few minutes and won’t start: the start relay, a small part on the side of the compressor.
  • No ice, or water on the floor: the water inlet valve or the ice maker.
  • Runs, but nothing gets cold: the compressor or a refrigerant leak, which is sealed-system work.

One caution on LG-built 795 refrigerators: LG’s compressor warranty terms are written for LG-branded models, so don’t assume they cover a Kenmore-badged unit. Check the warranty that came with your refrigerator before paying for a compressor. More on our refrigerator repair page.

Kenmore dishwashers and ranges

Whirlpool-built Kenmore dishwashers (665) usually need a drain pump, an inlet valve or float switch, a door latch or a control board. Before calling about one that won’t drain, clean the filter in the tub floor and check the drain hose under the sink for kinks.

Frigidaire-built Kenmore ranges (790) have the usual oven failures: a weak bake igniter that glows but never lights the burner on gas models, a burned-out bake element on electric models, a temperature sensor or a control board. See oven and range repair for what we test.

What does Kenmore appliance repair cost in Los Angeles?

Kenmore appliance repair in Los Angeles costs about the same as repairing the maker’s own models, because the parts and the labor are the same. Typical Los Angeles County and Orange County prices, parts and labor included:

Appliance Repair Typical price
Washer Drain pump $190–$340
Washer Lid switch or door lock $160–$300
Washer Door boot (front-load) $220–$420
Washer Tub bearing and seal $450–$750
Dryer Thermal fuse or thermostat $140–$240
Dryer Heating element, igniter or gas valve coils $170–$320
Refrigerator Start relay $160–$280
Refrigerator Fan motor or defrost part $190–$360
Refrigerator Compressor or sealed system $650–$1,400
Dishwasher Drain pump $190–$330
Range Bake igniter or element $170–$340

The diagnostic ($69 for washers, dryers, dishwashers and ranges; $85 for refrigerators) covers the trip, the testing and a written quote, and it’s applied to the repair if you go ahead. Prices are the same across both counties, with no travel charge.

Safe checks before you call

Several Kenmore problems can be narrowed down safely from the outside of the appliance. Unplug it or switch off its breaker before touching anything behind a panel.

  1. Photograph the model tag. The full model and serial number let the technician bring the right parts.
  2. Check the breaker. Electric dryers and ranges run on 240-volt circuits; if one side is off, an electric dryer can tumble with no heat.
  3. Washer won’t drain: straighten the drain hose. Many front-loaders have a pump filter behind a small panel at the bottom front; put towels down first.
  4. Dryer slow or cold: clean the lint screen and check the duct behind the dryer for crushing or kinks.
  5. Refrigerator warm: unplug it, vacuum the condenser coils, plug it back in, and clear anything blocking the vents inside.

Stop and call instead if you smell gas (leave without touching switches and call SoCalGas or 911 from outside), see scorch marks, smell burning, find water near wiring, or the breaker trips again after a reset.

Is an old Kenmore worth repairing?

An old Kenmore is often worth repairing. Repair when the quote is under half the price of a comparable new unit and the appliance has life left: roughly 10–12 years for refrigerators, washers and dishwashers, and about 15 for dryers and ranges. A thermal fuse on a Whirlpool-built dryer passes that test easily.

The usual exceptions are a sealed-system failure on a refrigerator past about 10 years and tub bearings on an older washer. If your Kenmore is on the wrong side of the line, the technician tells you in writing at the diagnostic, before you spend anything more.

When to call a technician

Call a technician when a safe check doesn’t fix the Kenmore, when the repair means opening the cabinet, or right away for a warm refrigerator, a leak or a burning smell. Pros Fix Appliances is an independent repair company, not affiliated with Sears or Kenmore, and repairs Kenmore appliances across Los Angeles County and Orange County with parts matched to the model number.

Calls placed before noon are usually seen the same day; later calls are typically seen the next business day. The diagnostic is $69, or $85 for refrigerators, applied to the repair you approve. Call (866) 696-7767 or book online, and have the model number handy.

Frequently asked questions

Who makes Kenmore appliances?

Kenmore doesn’t manufacture anything. It’s a store brand created by Sears and owned by Transformco since 2019, and its appliances were built by other companies, including Whirlpool, LG, Electrolux (Frigidaire), GE, Samsung and Panasonic. The three digits before the dot in your model number usually identify which one built yours.

Is Kenmore the same as Whirlpool?

Only some Kenmores are. Models whose numbers start with 106, 110 or 665 are generally Whirlpool-built and share most parts with Whirlpool siblings. Others were made by LG, Frigidaire, GE or Samsung and use that maker’s parts instead, so parts should always be matched to the full model number.

Can you still get parts for a Kenmore appliance?

Usually. Sears PartsDirect still lists parts by Kenmore model number, and most mechanical parts are shared with the original maker’s own models. The parts most likely to be discontinued on older units are the ones made only for the Kenmore version, such as control consoles and trim pieces.

About the author — Emanuel “Manny” Misayeledis is the owner and lead technician of Pros Fix Appliances in Glendale (California BHGS registration A49955). He and his team repair residential and built-in appliances across Los Angeles County and Orange County. Last updated: November 3, 2026.

Scroll to Top