Short answer: A dryer banging noise usually comes from the load (shoes, a balled-up sheet, zippers) or a loose object near the blower. If the thump repeats every drum turn, suspect worn drum rollers or the belt; a squeal that turns into thumping points to the idler pulley. Belt, roller and idler repairs typically cost $190–$340 in Los Angeles.
This guide is for anyone whose dryer has started banging, thumping or knocking. A dryer is a heavy drum riding on small rollers and turned by a belt, so most noises can be narrowed down by ear before anyone opens it, and priced from our Los Angeles and Orange County ranges.
What does each dryer noise mean?
Timing is the best clue to a dryer noise. The drum turns slowly while the motor and blower spin many times faster, so a noise that keeps time with the drum points to drum parts, and a fast, steady rattle points to the blower or motor.
| Sound | When you hear it | Likely cause | Typical fix |
|---|---|---|---|
| Thump once per drum turn | Every load, getting louder | Worn drum roller or a lumpy belt | Belt, rollers and idler kit |
| Thump that fades as the dryer runs | After the dryer sat unused | Rollers flattened while idle | None; they regain their shape |
| Irregular banging or clunking | Only with certain loads | Shoes, rugs, balled-up sheets, buckles | Change the load |
| Fast, steady rattle or knock | Even with the drum empty | Object in the blower wheel | Remove it; repair any damage |
| Squeal that turns into thumping | Worse over weeks | Idler pulley bearing failing | Belt, rollers and idler kit |
| One loud bang, then no tumbling | Motor may still hum | Broken drive belt | New belt, usually with the kit |
| Scraping or grinding at the drum edge | Every load | Worn drum glides or rear bearing | Replace glides or bearing |
| Rocking or knocking against the wall | While tumbling | Unlevel feet or items touching it | Level it; clear space |
| Muffled boom from the base of a gas dryer | As the burner lights | Delayed burner ignition | Stop using it and call |
Why is my dryer making a banging noise?
A dryer banging noise usually comes down to one of eight causes, and we work through them from free fixes to parts.
1. The load
Tennis shoes, bath mats and sheets that wind into a ball thump hard on every turn; Whirlpool recommends a drying rack for shoes. Zippers, buckles, buttons, coins and pens rattle and knock, so empty pockets before washing.
2. An object past the lint screen
Coins, bobby pins and small socks can slip into the lint-screen housing and reach the blower wheel, the fan that pulls air through the drum. Whirlpool notes they knock as the wheel spins. Anything you can’t see with a flashlight needs the cabinet opened.
3. Worn drum rollers
Most dryers carry the back of the drum on two rollers (some use a rear bearing instead) and the front on glides or a second pair of rollers. In the photo at the top of this guide, from one of our service calls, the rear rollers are the black wheels with blue hubs. Worn rollers develop flat spots or wobble on their axles and thump once per turn; unlike the temporary flat spots Whirlpool describes after a dryer sits unused, the thump doesn’t fade. Rollers are replaced in pairs, usually with the belt and idler.
4. A failing idler pulley
The idler is a spring-loaded pulley that keeps the belt tight. Its bearing wears, so the noise often starts as a squeal or chirp and turns into thumping or grinding as the pulley wobbles; Whirlpool attributes squealing to worn belts and pulleys and to lint around them. A seized idler can burn through the belt.
5. A damaged or broken belt
The belt wraps around the whole drum. A frayed or lumpy belt slaps or thumps; a broken one usually ends with a single bang, then the drum stops while the motor runs or hums.
6. Worn glides or rear bearing
Glides are the plastic or felt pads the front of the drum slides on. When they wear through, the drum drops and scrapes, and fabric can catch at the front edge. On designs with a rear bearing, a worn bearing squeals or grinds from the back.
7. The motor or the installation
A motor with worn bearings growls or knocks. Outside the dryer, Whirlpool lists missing or unlevel feet, items leaning against the dryer and things rattling in a pedestal drawer. On stacked units, a loose stacking kit or a washer that walks on spin can sound like the dryer; see stacked washer-dryer repair and why a washer shakes on spin.
8. A boom from a gas burner
A soft boom or whoosh from the base of a gas dryer as the burner lights isn’t a drum noise. It suggests delayed ignition, with gas building up before it lights, so the burner needs checking before the next load. If you ever smell gas, leave the house without touching switches and call SoCalGas at 1-800-427-2200 or 911 from outside.
Safe checks for a noisy dryer
- Run it empty for two minutes. If the noise stops, the load caused it.
- Check the load and pockets for shoes, rugs, zippers, buckles and coins.
- Unplug the dryer or switch off its breaker before the next steps.
- Look into the lint-screen housing with a flashlight and remove anything you can reach without tools.
- Turn the drum slowly by hand. A catch, a rough spot or a thunk you can feel points to a roller, the idler or the belt.
- Level the dryer: all four feet on the floor, level front to back and side to side, with nothing touching it and the pedestal drawer empty.
Stop and call if you smell burning rubber or hot metal, the drum stops turning, you hear grinding, or a gas dryer booms when it lights. Don’t open the cabinet: panel edges are sharp, electric dryers carry 240 volts, and gas dryers have a burner and gas line inside.
How much does it cost to fix a banging dryer?
Most banging-dryer repairs cost $190–$340 in Los Angeles County and Orange County, parts and labor, because the usual parts come as one kit. The exact price is written before work starts.
| Repair | What it fixes | Typical LA price |
|---|---|---|
| Belt, rollers and idler kit | Thumping, squealing, a broken belt | $190–$340 |
| Drive motor | Growling or knocking motor bearings | $280–$480 |
| Glides, rear bearing or blower wheel | Scraping, grinding, a fast rattle | Quoted after diagnosis |
| Load, leveling, objects you can reach | Most banging and knocking | Free |
The $69 dryer diagnostic is applied to the repair, with no travel charge across LA County and Orange County. Repair or replace? A roller, idler and belt kit passes our 50% rule (repair when the quote is under half the price of a comparable new dryer) on almost any dryer with life left; dryers typically last about 15 years. A motor on an older, inexpensive dryer is the case to compare against a new one.
When to stop using it and call
Keep using a noisy dryer only if the noise is clearly the load, or flat spots that fade as it runs. Stop for burning smells, grinding, a drum that won’t turn, or a gas-burner boom; running on a seized roller or idler can burn the belt and overheat the motor. Call (866) 696-7767 or book online; calls placed before noon are usually seen the same day across Los Angeles County and Orange County, and later calls typically the next business day. More on what we fix is on our dryer repair page.
Frequently asked questions
Why does my dryer thump when it first starts?
If the dryer sat unused for a while, the rubber drum rollers can flatten where they rest against the drum; Whirlpool says they regain their shape after running for some time and the thump fades. If the thump lasts all cycle, every cycle, the rollers or belt are worn and need replacing.
Is it safe to keep using a dryer that’s banging?
If the bang is shoes or a balled-up load, yes; just change the load. A mechanical noise is different: a seized roller or idler can burn through the belt and strain the motor, and a gas-burner boom needs a technician first. When in doubt, unplug it and have it checked.
Why did my dryer bang loudly and then stop tumbling?
That’s the classic sign of a broken drive belt. The belt wraps around the drum, so when it snaps the drum stops while the motor runs or hums. The rollers and idler pulley are usually worn too, so they’re replaced together as a kit, typically $190–$340 in Los Angeles.
Can I replace dryer rollers myself?
Handy owners do, but it means unplugging the dryer, removing panels and lifting out the drum, and a gas dryer’s line shouldn’t be strained or disconnected. Replace rollers as a pair, ideally with the belt and idler. If any step is unfamiliar, have a technician do it.
