Short answer: Comparing a gas vs electric range for repairs, neither clearly breaks less; they wear out different parts. In Los Angeles, gas range repairs (igniters, spark modules, burner valves) typically cost $160–$360 and electric ones (elements, switches, glass-top elements) $150–$400. Both share sensors and control boards ($160–$650). Induction power modules cost the most: $450–$900.
This guide is for homeowners, landlords and property managers deciding between a gas and an electric range, or deciding whether to keep repairing the one they have. It’s written from the repair side: what actually wears out on gas, electric and induction ranges, what each repair costs in Los Angeles and Orange County, and when replacement makes more sense. It doesn’t try to settle cooking preference or energy bills.
Does a gas or an electric range break down more?
Neither a gas nor an electric range breaks down more as a category: we know of no independent data showing that one fuel type fails more often. What differs is which parts wear out, and the repair bills end up in similar ranges.
Ovens fail predictably. Gas ovens lose their igniter; electric ovens lose a bake element or a relay; and both eventually lose a temperature sensor. On the cooktop, gas burners fail at the spark igniter and module, while electric burners fail at the element and the switch behind the knob. The biggest cost difference isn’t gas versus electric at all. It’s how much electronics the range carries: a basic coil-top range is the cheapest to keep running, and induction is the most expensive.
Common gas range failures and costs
On a gas range, the parts that wear are the ones that light the gas. The oven igniter is the most predictable failure, followed by burner igniters, spark modules and the occasional burner valve.
- Oven bake or broil igniter ($170–$320). The oven heats slowly or not at all because a weak igniter can’t open the gas valve; see our guide to an oven igniter that won’t light.
- Burner igniter electrode or spark module ($160–$300). Constant clicking or a burner that won’t light, often after a boil-over soaks the igniter.
- Gas burner valve ($190–$360). A burner whose flame won’t adjust or won’t shut off cleanly.
- Temperature sensor ($160–$280) and relay or control board ($280–$650), the same as on electric models.
- Professional ranges such as Wolf and Viking: igniter and valve service runs $320–$720.
Gas adds one rule electric doesn’t have: if you smell gas, don’t touch switches; leave and call SoCalGas at 1-800-427-2200 or 911 from outside, as SoCalGas advises.
Common electric range failures and costs
On an electric range, the heating elements and the switches that control them do most of the wearing out. Coil-top ranges are the simplest and cheapest to fix; glass-top (radiant) ranges add a pricier element and the glass itself.
- Coil element or infinite switch ($150–$290). One burner dead or stuck on high; an infinite switch is the control behind each knob that sets the heat level. See our guide to an electric stove burner that won’t heat.
- Radiant element under a glass top ($220–$400).
- Oven bake or broil element ($180–$340). Often fails with a visible blister or break.
- Temperature sensor ($160–$280) and relay or control board ($280–$650).
- Cracked glass cooktop. Replaceable only if the manufacturer still sells the glass for your model, so it’s priced after we check availability.
Which costs more to repair, a gas or an electric range?
Typical repairs cost about the same on either type. The outliers are induction power modules and professional gas ranges at the top, and coil-top electric ranges at the bottom.
| What fails | Gas range | Electric range |
|---|---|---|
| Oven heat source | Bake or broil igniter: $170–$320 | Bake or broil element: $180–$340 |
| Cooktop burner | Igniter electrode or spark module: $160–$300 | Coil element or infinite switch: $150–$290 |
| Higher-cost cooktop part | Gas burner valve: $190–$360 | Glass-top radiant element: $220–$400 |
| Oven temperature sensor | $160–$280 | $160–$280 |
| Relay or control board | $280–$650 | $280–$650 |
| Premium option | Wolf or Viking igniter/valve service: $320–$720 | Induction power module: $450–$900 |
Prices are typical Los Angeles County and Orange County ranges, parts and labor included; the exact price is written after the $69 diagnostic, which is applied to the repair.
Is an induction range harder to repair?
An induction range is the most electronic of the three, so its expensive repairs are electronic too. Under the glass, a power module drives a coil that makes the pan itself heat, which only works with magnetic cookware.
Before assuming a fault, check the pan: if a magnet doesn’t stick firmly to its base, the cooktop won’t detect it. When a zone really has failed, the usual culprit is a power module ($450–$900), and modules are often special-order parts, so plan on a second visit. Our guide to an induction cooktop not detecting a pan covers the free checks.
How long do gas and electric ranges last?
Plan on roughly 15 years for either type. We don’t have reliable evidence that gas outlasts electric or the reverse; care and the quality of the model matter more than the fuel.
What usually ends a range’s working life isn’t one worn part. It’s a costly repair, such as a control board or a discontinued glass top, arriving on an older, inexpensive model where it no longer makes financial sense.
Switching between gas and electric in LA
Switching between a gas and an electric range comes down to the hookup. An electric or induction range needs a dedicated 240-volt circuit; a gas range needs a gas supply line plus a standard 120-volt outlet for its controls and igniters.
- Going electric or induction in a kitchen wired only for gas usually means an electrician adding a 240-volt circuit before the range can be installed.
- Going gas means a plumber or gas contractor running and testing a line. We install and connect ranges, but we don’t install gas lines.
- Power outages: a gas range isn’t fully outage-proof, because a modern gas oven’s safety valve opens only when electric current flows through its igniter.
- Earthquakes: if your gas is shut off at the meter, SoCalGas turns it back on and relights pilots; don’t do it yourself.
In apartments and condos, the building’s existing hookup usually settles the question, and a like-for-like replacement is the simplest and least expensive route.
Should you repair or replace your range?
Use the 50% rule: repair when the written quote is under half the price of a comparable new range and the range has life left, about 15 years in total. Most of the repairs above pass easily.
- Almost always repair: igniters, elements, switches, sensors and burner valves on a range that isn’t near the end of its life, and nearly any repair on a professional range, which is built to be serviced.
- Think it over: a control board or an induction module on a basic range near the end of its life.
- Usually replace: an inexpensive range near 15 years old that needs a board, or whose glass top is discontinued.
Our technician will tell you in writing which side of the line your range falls on. The $69 diagnostic is the same across Los Angeles County and Orange County, with no travel charge, and calls placed before noon are usually seen the same day. Call (866) 696-7767 or book online; our oven repair and stove and cooktop repair pages list everything we fix.
Frequently asked questions
Is a gas or electric stove cheaper to repair?
They cost about the same for typical repairs: roughly $150–$400 in Los Angeles for igniters, elements, switches and valves, and $280–$650 for a control board on either type. Basic coil-top electric ranges are the cheapest to keep running; induction modules ($450–$900) are the most expensive.
Do gas stoves last longer than electric stoves?
There’s no reliable evidence either way that we can point to. Plan on about 15 years for a range of either type. Care, the quality of the model and whether parts stay available matter more than whether it burns gas or uses electricity.
Can I switch from a gas range to an electric or induction range?
Yes, if the kitchen has, or can get, a dedicated 240-volt circuit; that’s electrician work. The old gas line should be capped by a qualified professional. Once the circuit is in, the new range is a standard installation and connection.
What is the most expensive range repair?
Induction power modules ($450–$900) top the list, followed by professional gas range igniter and valve service ($320–$720) and control boards ($280–$650). A cracked glass cooktop can also be costly, and on some older models the glass is no longer made.
