Short answer: E24 and E25 on a Bosch dishwasher mean water isn’t draining: a clogged filter, blocked drain pump or loose pump cover, kinked drain hose, clogged air gap or disposal knockout plug. E15 means water reached the base and tripped the leak protection — shut off the water and find the leak. A drain pump typically runs $190–$330 in LA.
This guide is for Bosch owners in Los Angeles County and Orange County with E24, E25 or E15 on the display. It explains what Bosch’s own support pages say each code means, the checks you can do safely, why tipping the dishwasher to clear E15 is a bad idea, and what repairs cost.
What do E24, E25 and E15 mean on a Bosch dishwasher?
E24 and E25 are drain faults: the dishwasher couldn’t pump the water out. E15 is a leak alarm: water has reached the base of the machine, under the tub, and the leak protection has shut things down. Here’s how Bosch’s US error-code list describes them, with two related drain codes.
| Code | Four-digit version | What Bosch says it means | What to check | When to call |
|---|---|---|---|---|
| E24 | E6103 (E61-03) | Not draining properly | Filter, pump cover, drain hose, air gap, disposal knockout plug | Returns after the checks and a reset |
| E25 | E6102 (E61-02) | Drain pump blocked, or its cover loose or missing | Pump cover and the pump under the filter | Pump hums or stays silent after clearing |
| E22 | E9240 | Filter blocked | Wash the filter | Returns with a clean filter |
| E23 | E6101 | Drain pump blocked, clogged or faulty | Pump cover for debris | Bosch says to contact support |
| E15 | E3100 | Safety switch detected water in the base; leak protection activated | Shut off the water; look for visible leaks | Right away |
Bosch describes E24 two ways on its own pages — as a blocked drain filter, and as a blocked pump, kinked hose or clogged air gap — so check the whole drain path, not just the filter.
Why does my Bosch show E6103 or E3100 instead?
Because Bosch uses two code formats for the same faults, and which one you see depends on your model. Bosch’s US list pairs them: E6103 matches E24, E6102 matches E25 and E3100 matches E15, and some displays show the four-digit codes with a dash, such as E61-03.
Bosch doesn’t publish which models use which format, so go by your model number. It’s on the rating label, and Bosch’s model-number finder shows where to look. With the model number you can pull up the owner’s manual for your exact machine, and a technician can confirm the code before ordering parts.
How do you clear E24 or E25?
Clear the drain path from the inside out, then reset. Stop at any step that clears the code.
- Turn the dishwasher off. Before your hand goes into the sump, switch off its breaker as well.
- Take out the lower rack, remove the filter, and wash it under the tap with mild soap and a soft brush, as Bosch recommends.
- Bail the water out of the sump with a cup and sponge. Wear gloves — Bosch warns some debris may be sharp.
- Find the drain pump cover, the small cover in the sump under the filter. Bosch’s method: pry it up with a spoon until it clicks, pull up until you feel resistance, then pull it forward. Clear out glass, pits or labels, and press the cover back until it clicks into place. A cover that isn’t clicked in can cause E25 on its own.
- Under the sink, straighten any kink in the drain hose, pull the air gap cap and clean it, and run the disposal. If the disposal was installed recently, make sure its knockout plug was removed — Bosch lists this for E24.
- Reset: switch the dishwasher off at the power button or breaker for about a minute, switch it back on, and run a short cycle with no dishes in it.
Listen at the drain step of that test. A hum with no water moving means the pump is jammed or seized; silence means it isn’t running at all. Either way, the problem is now the pump or its control, and it’s time for a technician.
What should you do about E15?
Shut off the water and find the leak. E15 means Bosch’s leak protection has done its job: a float switch in the tray under the tub has detected water in the base. Bosch’s instruction for E15 is to turn off the water inflow and contact its customer support.
- Turn off the water valve under the sink and switch the dishwasher off.
- Check the floor in front of the dishwasher and under the sink. If water is near the outlet or wiring, switch off the breaker before you touch anything.
- Look at the hoses and connections you can see for drips, kinks or damage — the check Bosch’s UK support page suggests.
- If anyone used hand dish soap in the dishwasher, tell the technician — suds can overflow into the base and trip E15.
- Leave the dishwasher off and call. A dishwasher that has just shown E15 shouldn’t run another cycle until the leak is found.
Why we don’t recommend tipping it. Online advice often says to tip the dishwasher back to drain the tray and clear the code. A built-in dishwasher is fastened to the counter and connected to water, drain and power, and tipping it strains all three. A dry tray also fixes nothing: if the leak is still there, E15 comes back. The usual sources are a hose connection or the inlet valve, the drain pump or its seal, the sump gasket or the door seal — a technician drains the tray while finding which one.
In a condo or apartment, treat E15 as urgent. Water in the base means water has already left the tub, and a slow leak can reach the unit below.
What does a Bosch drain or leak repair cost?
Most E24, E25 and E15 repairs are one part plus labor. Our dishwasher diagnostic is $69 — trip, testing and a written quote — and it’s applied to the repair when you approve it. Typical Los Angeles County and Orange County prices, parts and labor, with the same fees in both counties and no travel charge:
- Drain pump: $190–$330
- Inlet valve or float switch: $170–$300
- Wash pump or circulation motor: $280–$520
- Control board: $260–$560
- Hose, seal or gasket leak: priced after diagnosis
Is it worth it? Repair when the quote is under half the price of a comparable new dishwasher and the machine has life left. A drain pump on a seven-year-old Bosch usually clears that bar easily. If your Bosch is still under the manufacturer’s warranty, call Bosch first.
When should you call a technician?
Call when E24 or E25 comes back after the checks and a reset, when the pump hums or stays silent, or as soon as E15 appears. Calls placed before noon are usually seen the same day across Los Angeles County and Orange County; later calls are typically next business day. Call (866) 696-7767 or book online, and see our dishwasher repair service for the brands we work on.
No code, just standing water? Our guide to a dishwasher not draining walks through every brand. If the dishwasher won’t start a cycle at all, see dishwasher won’t start. Miele owners can use our Miele F11 and F13 guide.
Frequently asked questions
Can I reset a Bosch E15 error myself?
A power reset may clear the display, but E15 means water reached the base and tripped the leak protection, so it comes back until the leak is fixed. Bosch’s instruction is to turn off the water supply and get service. Tipping the machine to drain the tray hides the problem rather than solving it.
Why does my Bosch show E24 when nothing is clogged?
Check the parts you can’t see from the tub: a pump cover that isn’t clicked fully into place, a kink in the hose behind the machine, a clogged air gap or a disposal knockout plug. If all are clear and E24 returns after a reset, the drain pump is usually weak or failed.
What is the difference between E24 and E25 on a Bosch?
Both are drain faults. Bosch describes E24 as water not draining properly — filter, hose, air gap or disposal — and E25 as a blocked drain pump or a loose or missing pump cover. The first checks are the same for both: filter, pump cover, drain hose and air gap.
What do Bosch codes E6103, E6102 and E3100 mean?
They’re the four-digit versions of the same faults on Bosch’s US code list: E6103 matches E24 (not draining), E6102 matches E25 (drain pump blocked or cover loose) and E3100 matches E15 (water in the base). Which format your dishwasher shows depends on the model.
How much does it cost to fix a Bosch dishwasher error in Los Angeles?
Our dishwasher diagnostic is $69 and is applied to the repair if you approve it. A new drain pump typically runs $190–$330, and an inlet valve or float switch $170–$300, in Los Angeles County and Orange County, parts and labor included. The exact price is written before any work starts.
