Ice maker troubleshooting guide

Most ice maker problems are water supply problems: a closed valve, a clogged filter, a kinked line or a frozen fill tube. Pick what yours is doing for safe checks for refrigerator and undercounter ice makers and when to stop and call.

Last updated

Troubleshoot your ice maker

Add the brand and model number for brand notes and error codes, then pick what it's doing. Nothing you type leaves this page.

Appliance Ice maker

Brand-specific steps and error codes, if we know the series.

What's the ice maker doing?

Ice maker not making ice

An ice maker that stopped usually has its switch off, a freezer warmer than about 10°F, a closed water valve or a clogged filter. If water reaches it and the freezer is at 0°F, the ice maker or its water valve needs a technician.

Most likely, in the order we find it: Inlet valve, frozen fill line, ice-maker module, filter, or the freezer temperature.

  1. Turn it on

    Check the switch, the wire arm (down to make ice) or the setting on the display, and push the bin fully in.

  2. Set the freezer to 0°F

    Most ice makers slow down or stop above about 10°F.

  3. Open the water

    Check that the supply valve is fully open, and replace a filter older than about six months.

  4. Look for a frozen fill tube

    Ice where the water enters the ice maker blocks it.

    See the frozen-up steps below.

  5. Wait 24 hours

    The first batch after a restart takes about a day.

    Still nothing: call.

Still not working?

What we check
Water supply, valve, module cycle, freezer temperature
Typical repair
Water inlet valve $170–$300 · Ice-maker assembly (refrigerator) $220–$420Parts and labor, typical for LA, OC & Ventura; written quote before any work.
The visit
$85 diagnostic, applied to the repair · Usually same-day

Ice maker making small or hollow cubes

Small, hollow or half-formed ice means the ice maker isn't getting enough water: a clogged filter, low water pressure, a partly frozen fill tube or a weak inlet valve.

Most likely, in the order we find it: Low water pressure, a clogged filter, or a partly blocked valve.

  1. Replace the water filter

    Filters older than about six months restrict the flow.

  2. Open the supply valve fully

    Saddle valves that pierce the pipe often clog over time.

  3. Check the dispenser flow

    If water from the dispenser is slow too, the supply or the inlet valve is restricted.

    Strong water but small ice: the fill tube or the ice maker's fill setting.

Still not working?

What we check
Pressure, filter age, valve flow
Typical repair
Water inlet valve $170–$300Parts and labor, typical for LA, OC & Ventura; written quote before any work.
The visit
$85 diagnostic, applied to the repair · Usually same-day

Ice maker frozen up

An ice maker encased in ice, common in the door ice compartment of some French-door refrigerators, usually has humid air leaking into the ice room and meltwater refreezing. Defrosting clears it for a while; a lasting fix reseals or repairs the ice room.

Most likely, in the order we find it: Ice-room fan or heater, a leaking ice-room seal, or a frozen fill tube.

  1. Turn the ice maker off

    Use the switch or the Ice Off setting.

  2. Thaw it

    Remove the ice bucket and let the ice compartment thaw with the door open and towels down. Don't chip the ice with anything sharp.

  3. Check the ice room seal

    Make sure the ice compartment's cover and the door seal close properly.

  4. Call if it refreezes

    If it freezes up again within weeks, the seal, the drain or a heater needs repairing.

Still not working?

What we check
Ice-room temperature, fan, heater, seal, fill tube
Typical repair
Fill tube / ice-room repair (Samsung/LG) $240–$480Parts and labor, typical for LA, OC & Ventura; written quote before any work.
The visit
$85 diagnostic, applied to the repair · Usually same-day

Ice maker won't stop making ice

An ice maker that overfills the bin has a shut-off arm or bin sensor that isn't telling it the bin is full: a stuck arm, a bin that isn't pushed in, or ice blocking the sensor.

Most likely, in the order we find it: Shut-off arm or bin sensor, or the ice-maker module.

  1. Check the shut-off arm and the bin

    Make sure the wire arm moves freely and the bin is pushed fully in.

  2. Clear the sensor

    On models with an infrared sensor, wipe the sensor windows and clear any ice.

  3. Turn it off and call

    If it keeps overfilling, the sensor or the control needs replacing.

Still not working?

What we check
Arm or optical sensor, module
Typical repair
Ice-maker assembly (refrigerator) $220–$420Parts and labor, typical for LA, OC & Ventura; written quote before any work.
The visit
$85 diagnostic, applied to the repair · Usually same-day

Ice maker leaking or overflowing

An ice maker that leaks or overflows usually has a frozen fill tube, low water pressure, a cracked water line, or a water valve that doesn't close fully.

Most likely, in the order we find it: Inlet valve not closing, fill level, a cracked tray or fill cup.

  1. Turn the water off

    Close the supply valve to stop the leak.

  2. Check the fill tube

    Ice in the fill tube makes water spill instead of filling the mold.

  3. Call

    A valve that keeps dripping needs replacing.

Still not working?

What we check
Valve seal, fill adjustment, tray
Typical repair
Water inlet valve $170–$300Parts and labor, typical for LA, OC & Ventura; written quote before any work.
The visit
$85 diagnostic, applied to the repair · Usually same-day

Ice maker error codes by brand

Most ice makers show few codes. If yours shows one, write it down exactly, switch the breaker off for 1 minute and back on, and if it returns, call with the code and the model number.

Where's the model number on a ice maker?

It's on a sticker called the rating label, and you can reach it without tools. The model number tells the tool above (and our technician) which series you have; the serial number on the same label holds the build date. Watch 0 and O, 1 and I, 8 and B.

Ice makers inside a refrigerator

  • Open the fresh-food door.
  • Look here first: Use the refrigerator's own label: inside the fresh-food section, on a side wall near the top.
  • Then check: The ceiling of the fresh-food section. The ice maker's own part number isn't the one to use.
  • Read the line marked Model (Mod., M/N or Model No.), not Serial (Ser., S/N). Copy every character, including anything after a dash or slash.

Undercounter ice machines

  • Open the door.
  • Look here first: Inside, on a side wall or the door frame.
  • Then check: Behind the grille at the bottom front, or in the manual or on the receipt. Don't pull a built-in unit out to read a label on the back.
  • Read the line marked Model (Mod., M/N or Model No.), not Serial (Ser., S/N). Copy every character, including anything after a dash or slash.
Can't find the label?
  • Check the owner's manual, the receipt, the delivery paperwork or the registration card.
  • If it's connected to the brand's app, the model number is in the app's device information.
  • Can't read it? Take a photo with the flash off, holding the phone at a slight angle so it doesn't glare, then zoom in.
  • Still nothing? Skip it. The guide works without a model number, and our technician will find it at the visit.
How ice maker model numbers start, by brand
BrandModel number starts with
GE MonogramZDI: undercounter ice maker
JennAirJUI: undercounter ice maker
KitchenAidKUI: undercounter ice maker
Sub-ZeroUC-15I: undercounter ice maker
U-LineUCP, UHCP, CLR: ice maker
VikingVUIM, RVUI: undercounter ice maker
WhirlpoolWUI: undercounter ice maker

The full guide to finding a model number

Brand notes

  • Samsung. Ice building up around the ice maker in the left door of a French-door model is a known Samsung problem: humid air gets into the ice room and meltwater refreezes. Samsung ice maker frozen over
  • Kenmore. Kenmore appliances are built by other makers, and the three digits before the dot in the model number say which: 110 is Whirlpool laundry, 795 LG refrigerators, 253 Frigidaire refrigerators and freezers. Error codes follow that maker. Kenmore appliance repair

Questions people ask

How long does a new or reset ice maker take to make ice?

Usually about 24 hours for the first full batch once the freezer is at 0°F, and it's worth throwing away the first few batches. Undercounter ice machines can take longer to fill the bin. If nothing appears after a day, check the water supply and the filter.

How much does ice maker repair cost in Los Angeles?

Most ice maker repairs we do in Los Angeles, Orange and Ventura counties run $170–$650 for parts and labor, for example water inlet valve $170–$300 and ice-maker assembly (refrigerator) $220–$420. The diagnostic is $85, applied to the repair, and you get a written quote before any work starts.

Is it worth repairing my ice maker?

Usually, while the repair costs less than half the price of a comparable new ice maker and it has life left. Most ice makers last 8–12 years, and premium brands 8–12. Past that age, or when the quote passes half the new price, replacing it is usually the better buy, and we'll tell you so.

Checked everything? Call before noon for a same-day visit.

Dispatch answers the phone and the technician arrives with the likely parts. $85 diagnostic, applied to the repair. Written quote before any work.

Call (866) 696-7767 Book online Mon–Fri 9 am–5 pm · Sat 10 am–2 pm · Emergency calls answered 24/7 · Calls before noon are usually seen the same day

The State of California's record for A49955

California DCA license search record: Household Goods and Services, Bureau of — Licensing details for 49955. Name: Pros Fix Appliances LLC. License type: Major Appliance Repair. License status: CLEAR. Address: 1201 N Pacific Ave #202, Glendale CA 91203, Los Angeles County. Issuance date July 11, 2023. Expiration date July 31, 2027. Current date November 6, 2026.
What the state's license search shows for Pros Fix Appliances LLC, as checked on Nov 6, 2026: status CLEAR, registered since July 11, 2023, valid through July 31, 2027. The live record is one click away — open it on search.dca.ca.gov ↗.