Range hood troubleshooting guide

Most range hood problems are greasy filters, a stuck damper or a failed switch or fan motor. Pick what yours is doing for safe checks on wall, island and insert hoods and when to stop and call.

Last updated

Troubleshoot your range hood

Add the brand and model number for brand notes and error codes, then pick what it's doing. Nothing you type leaves this page.

Appliance Range hood

Brand-specific steps and error codes, if we know the series.

What's the range hood doing?

Range hood fan not working

A range hood fan that won't run usually has its switch or breaker off, a stuck control, or a failed fan motor or capacitor. Check the power first; motors and controls need a technician.

Most likely, in the order we find it: Blower motor, speed switch or control board, capacitor.

  1. Check the switch and the breaker

    Hoods often run off a wall switch or their own breaker.

  2. Reset it

    Switch it off at the breaker (or unplug it) for 1 full minute, then switch it back on.

  3. Call

    A hum with no spin is usually the motor or its capacitor; nothing at all is the control or the switch.

Still not working?

What we check
Power at the switch, motor windings, capacitor, board
Typical repair
Fan motor $220–$420 · Switch or LED driver $150–$280Parts and labor, typical for LA, OC & Ventura; written quote before any work.
The visit
$69 diagnostic, applied to the repair · Usually same-day

Range hood weak suction

Weak suction is almost always greasy filters, a damper that won't open, or a hood switched on too late or too low. Clean the filters first.

Most likely, in the order we find it: Clogged grease filters, a blocked duct or stuck damper, a motor losing speed.

  1. Clean the filters

    Metal mesh and baffle filters go in the dishwasher or soak in hot, soapy water. Charcoal filters on recirculating hoods need replacing.

  2. Check the damper

    Outside, or where the duct leaves the hood, the flap should open when the fan runs.

  3. Use it the right way

    Switch the hood on a few minutes before cooking, and use a higher speed for searing and frying.

  4. Call

    Still weak: the fan, the duct or the damper needs checking.

Still not working?

What we check
Filters, duct run and damper, motor speed under load
Typical repair
Fan motor $220–$420Parts and labor, typical for LA, OC & Ventura; written quote before any work.
The visit
$69 diagnostic, applied to the repair · Usually same-day

Range hood lights out

Range hood lights that are out usually need a new bulb or LED module of the right type. If new bulbs don't work, the switch or the control board has failed.

Most likely, in the order we find it: Bulbs or LED driver, the light switch, wiring.

  1. Replace the bulb

    Check your manual for the bulb type, and let a halogen bulb cool first.

  2. Call

    LED modules and controls are a quick repair.

Still not working?

What we check
Lamp, driver output, switch
Typical repair
Switch or LED driver $150–$280Parts and labor, typical for LA, OC & Ventura; written quote before any work.
The visit
$69 diagnostic, applied to the repair · Usually same-day

Range hood loud or rattling

A loud or rattling range hood usually has a loose filter, grease on the fan blades, a loose duct or a worn fan motor.

Most likely, in the order we find it: Blower wheel out of balance, motor bearings, a loose duct or damper.

  1. Seat the filters

    Make sure every filter clicks into place.

  2. Clean the filters

    Grease on the filters and fan makes it louder and weaker.

  3. Call

    A fan or motor that grinds should be replaced before it fails.

Still not working?

What we check
Wheel, bearings, duct connections
Typical repair
Fan motor $220–$420Parts and labor, typical for LA, OC & Ventura; written quote before any work.
The visit
$69 diagnostic, applied to the repair · Usually same-day

Range hood error codes by brand

Most range hoods show few codes. If yours shows one, write it down exactly, switch the breaker off for 1 minute and back on, and if it returns, call with the code and the model number.

Where's the model number on a range hood?

It's on a sticker called the rating label, and you can reach it without tools. The model number tells the tool above (and our technician) which series you have; the serial number on the same label holds the build date. Watch 0 and O, 1 and I, 8 and B.

  • Take out the grease filters. Most push or slide out; let them cool if you've been cooking.
  • Look here first: Inside the hood, on a wall behind the filters. A flashlight helps.
  • Then check: Higher up inside the hood, near the fan, or in the owner's manual.
  • Read the line marked Model (Mod., M/N or Model No.), not Serial (Ser., S/N). Copy every character, including anything after a dash or slash.
Can't find the label?
  • Check the owner's manual, the receipt, the delivery paperwork or the registration card.
  • If it's connected to the brand's app, the model number is in the app's device information.
  • Can't read it? Take a photo with the flash off, holding the phone at a slight angle so it doesn't glare, then zoom in.
  • Still nothing? Skip it. The guide works without a model number, and our technician will find it at the visit.
How range hood model numbers start, by brand
BrandModel number starts with
BertazzoniKU, KC: range hood
BoschDUH, HCP, HCB, DPH: range hood
CaféCVW: range hood
Fisher & PaykelHC, HP, HS: range hood
FrigidaireFHWC, FHWW: range hood
GaggenauAW, AI, AL: range hood
GEJVX, UVW, PVX: range hood
GE MonogramZV: range hood
KitchenAidKVW, KVU: range hood
MieleDA: range hood
SamsungNK: range hood
ThermadorHMWB, HMCB, PH: range hood
VikingVWH, VCWH, VCIH, RVCH: range hood
WhirlpoolWVW, WVU: range hood
WolfVW, VI, PW, PL: range hood

The full guide to finding a model number

Brand notes

  • Kenmore. Kenmore appliances are built by other makers, and the three digits before the dot in the model number say which: 110 is Whirlpool laundry, 795 LG refrigerators, 253 Frigidaire refrigerators and freezers. Error codes follow that maker. Kenmore appliance repair

Questions people ask

How often should range hood filters be cleaned?

Metal mesh and baffle filters about once a month if you cook most days, and most can go in the dishwasher. Charcoal filters on hoods that recirculate can't be washed and need replacing every few months; your manual gives the interval.

How much does range hood repair cost in Los Angeles?

Most range hood repairs we do in Los Angeles, Orange and Ventura counties run $150–$650 for parts and labor, for example switch or LED driver $150–$280 and fan motor $220–$420. The diagnostic is $69, applied to the repair, and you get a written quote before any work starts.

Is it worth repairing my range hood?

Usually, while the repair costs less than half the price of a comparable new range hood and it has life left. Most range hoods last 12–15 years, and premium brands 15–20. Past that age, or when the quote passes half the new price, replacing it is usually the better buy, and we'll tell you so.

Checked everything? Call before noon for a same-day visit.

Dispatch answers the phone and the technician arrives with the likely parts. $69 diagnostic, applied to the repair. Written quote before any work.

Call (866) 696-7767 Book online Mon–Fri 9 am–5 pm · Sat 10 am–2 pm · Emergency calls answered 24/7 · Calls before noon are usually seen the same day

The State of California's record for A49955

California DCA license search record: Household Goods and Services, Bureau of — Licensing details for 49955. Name: Pros Fix Appliances LLC. License type: Major Appliance Repair. License status: CLEAR. Address: 1201 N Pacific Ave #202, Glendale CA 91203, Los Angeles County. Issuance date July 11, 2023. Expiration date July 31, 2027. Current date November 6, 2026.
What the state's license search shows for Pros Fix Appliances LLC, as checked on Nov 6, 2026: status CLEAR, registered since July 11, 2023, valid through July 31, 2027. The live record is one click away — open it on search.dca.ca.gov ↗.